| Hardware Specifications |
| Copper Ports |
4 x 10/100BASE-TX RJ45 TP
Auto-MDI/MDI-X, auto-negotiation |
| SFP Slots |
2 x 1000BASE-X SFP interfaces |
| DIP Switch |
| DIP Switch | Position | Function | | Mode | OFF | Ring | | ON (default) | Switch Mode |
Note :
1.Power off the IFGS-620TF before adjusting the DIP switch and then power it on.
2.The Ring function can reach simple Ring network with 8 units, the recovery time of data link can be as fast as 1ms.
3.Ring performance may vary depending on the length of the fiber optic and UTP cables. |
| DIP Switch |
Position |
| Mode |
OFF |
| ON (default) |
Switch Mode |
| Connector |
Removable 6-pin terminal block
Pin 1/2 for Power 1; Pin 3/4 for fault alarm; Pin 5/6 for Power 2 |
| Alarm |
Provides one relay output for power failure
Alarm Relay current carry ability: 1A @ DC 24V |
| ESD Protection |
±6KV air gap discharge
±6KV contact discharge |
| Surge Immunity |
6KV DC |
| Enclosure |
IP30 type metal case |
| Installation |
DIN-rail kit and wall-mount ear |
| Dimensions (W x D x H) |
32 x 87.8 x 135mm |
| Weight |
430g |
| Power Requirements |
DC 9~48V or AC 24V
Redundant power with reverse polarity protection |
| Power Consumption / Dissipation |
3.4watts/11.6BTU |
| LED |
3 x LED for System and Power: Green: DC Power 1 Green: DC Power 2 Red: Alarm 2 x LED for Per Copper Port (Port-1~Port-4): Green: 10/100 LNK/ACT 1 x LED for Per SFP interface (Port-5~Port-6) Green: 1G LNK/ACT |
| Switch Specifications |
| Switch Processing Scheme |
Store-and-Forward |
| Switch Fabric |
4.8Gbps |
| Throughput (packet per second) |
3.57Mpps@64bytes |
| Address Table |
4K entries |
| Jumbo Frame |
16K bytes |
| Flow Control |
Back pressure for half duplex IEEE 802.3x pause frame for full duplex |
| Standards Conformance |
| Standards Compliance |
IEEE 802.3 Ethernet
IEEE 802.3u Fast Ethernet IEEE 802.3ab Gigabit Ethernet
IEEE 802.3z Gigabit Ethernet 1000BASE-SX/LX
IEEE 802.3x Full-Duplex Flow Control
IEEE 802.1p Class of Service (Works under Ring function disable)
PROFINET Traffic Pass-through with QoS |
| Regulatory Compliance |
FCC Part 15 Class A, CE |
| Stability Testing |
IEC60068-2-32 (Free fall)
IEC60068-2-27(Shock)
IEC60068-2-6 (Vibration) |
| Environment |
| Temperature |
Operating: -40~75 degrees C
Storage: -40~75 degrees C |
| Humidity |
Operating: 5~95% (Non-condensing)
Storage: 5~95% (Non-condensing) |